User Manual

10/15/2012 Page 11 of 12
SignalFire Telemetry
Configuration/Debug
WARING: Only connect to the debug port in a safe area!
Debug and configuration information is available if a connection is made via the debug
port on the main board. A RS232 converter cable (available from SignalFire) must be
used for this interface.
Debug and advanced configuration may be done using the SignalFire SFToolKit PC
application. See the SFToolKit users manual for details on its use.
Technical Support Contact Information
SignalFire Telemetry
43 Broad St. A-403
Hudson, MA 01752
978-212-2868