User's Manual

4
Connections and Components
Radio LEDs
- The Radio TX LED (green) flashes each time a radio packet is sent. This LED will blink rapidly while
searching for the radio network and at boot up.
- The Radio RX LED (red) blinks on each received radio packet.
Status LEDs
- The STATUS LED (green) will blink on when the pressure sensor is sampled.
- The ERROR LED (red) will blink to indicate an error condition.
Checkin Button
- If this button is pressed the Scout will take a reading from the integrated pressure sensor and send the
data to the gateway.
Zero Button
- Allows the pressure sensor to be zeroed. Hold the ‘Zero’ button down for 3 seconds to zero the
pressure sensor. The status LED will come on and then blink twice to indicate that the sensor has been
zeroed.
SignalFire Telemetry
Rev 1.1