User's Manual

11
Configuration / Debug
WARNING: Only connect to the debug port in a safe area!
Debug and configuration information is available if a connection is made via the debug port on the main
board. A USB converter cable (available from SignalFire) must be used for this interface.
Debug and advanced configuration may be done using the SignalFire Toolkit PC application.
Technical Support and Contact Information
SignalFire Telemetry
43 Broad St C-300
Hudson, MA 01752
[phone]
[e-mail]
Revision
Date
Changes/Updates
1.0
10/1/16
Initial release
1.1
10/10/16
Updated control drawing, Edits to register map
SignalFire Telemetry
Rev 1.1