User Manual

4/18/2011 Page 3 of 8
SignalFire Telemetry - Rev 5.0
Setup
The Modbus-in-a-Stick requires initial configuration over the debug port. The supplied
SignalFire Modbus Configurator PC application will be used to configure the device over
the serial port.
The following items must be configured:
• Network Selection
• Check-in Period Selection (Pre-Configured Register set mode only)
• Modbus Slave ID and register configuration (Pre-Configured Register set mode
only)
The optional SignalFire Connector-Breakout-Board (CBB), pictured below provides an
easy means to connect to the RS232 lines and power the device while configuring the
system.