User's Manual

Rev 1.3 SignalFire Telemetry
5
Setup
The DIN Gateway requires an initial configuration over the debug port. The supplied
SignalFire Toolkit PC application will be used to configure the device over the serial port.
The following item must be configured:
- Radio Network and Group Selection
NOTE: If used with an Ethernet Gateway module the DB9 on the Ethernet module must be used for
ToolKit access.
Using the SignalFire Toolkit
The SignalFire Toolkit application can be downloaded at www.signal-fire.com/customer. After
installation, launch the software and the main toolkit window will open:
Select the COM port associated with the DIN Gateway and click “Auto-Detect Device on COM Port.”
This will open the device configuration window, where all device settings can be configured.