User's Manual

5
Setup
The nodes need to be set up for correct operation before being fielded. The configurable items
include:
- Network selection
- Check-in period selection
- Modbus Slave ID setting
All settings are made using the SignalFire Toolkit PC application and a serial programming cable.
Using the SignalFire Toolkit
The SignalFire Toolkit application can be downloaded at www.signal-fire.com/customer. After
installation, launch the software and the main toolkit window will open:
Select the COM port associated with the Flow Totalizer Node and click “Auto-Detect Device on COM
Port.” This will open the device configuration window, where all device settings can be configured.
WARNING: Perform the steps in this section (Setup) in a safe location only.
AVERTISSEMENT: Les étapes de démarrage (setup) doivent être fait dans une zone
sécuritaire.
SignalFire Telemetry
Rev 2.4