Specifications

SEAT BELT WARNING
A Weldon seat belt warning system, integrated with the Vehicle Data Recorder system, shall be installed
for each seat within the cab. The system shall activate an indicator light in the instrument panel, a
digital seat position indicator with a seat position legend in the switch panel, and an audible alarm.
The warning system shall activate when any seat is occupied with a minimum of 60 pounds and the
corresponding seat belt remains unfastened. The warning system shall also activate when any seat is
occupied and the corresponding seat belt was fastened in an incorrect sequence. Once activated, the
visual indicators and audible alarm shall remain active until all occupied seats have the seat belts
fastened.
SEAT MATERIAL
The seats shall be covered with Turnout Tuff™ rugged material. This material shall be semi- resistant
to UV rays and from being saturated or contaminated by fluids.
SEAT COLOR
All seats supplied with the chassis shall be gray in color. All seats shall include red seat belts.
SEAT BACK LOGO
The seat back shall include the “Smeal Fire Apparatus Co.” logo. The logo shall be centered on the
standard headrest of the seat back and on the left side of a split headrest.
SEAT DRIVER
The driver's seat shall be a Seats Inc. 911 Universal series. The four-way seat shall feature 3.00 inch
vertical travel air suspension and manual fore and aft adjustment with 6.00 inches of travel. The
suspension control shall be located on the seat below the left front corner of the bottom cushion. The
bottom seat cushion shall include an adjustment for rake angle offering added comfort.
The seat position shall include a three-point shoulder harness with lap belt and an automatic retractor
attached to the cab. The buckle portion of the seat belt shall be mounted on a semi-rigid stalk extending
from the seat base within easy reach of the occupant.
The minimum vertical dimension from the seat H-point to the ceiling for this belted seating position
shall be 37.00 inches measured with the seat suspension height adjusted to the upper limit of its travel.
This model of seat shall have successfully completed the static load tests set forth by FMVSS 207/210.
This testing shall include a simultaneous forward load of 3000 pounds each on the lap and shoulder belts
and twenty (20) times the weight through the center of gravity. This model of seat installed in the cab
model, as specified, shall have successfully completed the dynamic sled testing using FMVSS 208 as a