Specifications

The cab shall include one (1) 12 volt cigarette lighter type receptacle in the cab dash to provide a power
source for 12 volt electrical equipment. The receptacle shall be wired to be live with the battery master
switch.
STEP TRIM
Each cab entry door shall include a three step entry. The first step closest to the ground shall be
constructed of polished 5032 H32 aluminum Grip Strut® grating with angled outer corners. The step
shall feature a splash guard to reduce water and debris from splashing in to the step. The splash guard
shall have an opening on the outer edge to allow debris and water to flow through rather than becoming
trapped within the stepping surface. The lower step shall be mounted to a frame which is integral with
the construction of the cab for rigidity and strength. The middle step shall be integral with the cab
construction and shall be trimmed with a Flex-Tred
®
adhesive grit surface material.
UNDER CAB ACCESS DOOR
The cab shall include an aluminum access door in the left crew step riser painted to match the cab
interior paint with a push and turn latch. The under cab access door shall provide access to the diesel
exhaust fluid fill.
INTERIOR DOOR TRIM
The interior trim on the doors of the cab shall consist of an aluminum panel constructed of Marine Grade
5052-H32 0.13 of an inch thick aluminum plate. The door panels shall include a painted finish.
DOOR TRIM CUSTOMER NAMEPLATE
The interior door trim on the front doors shall include a customer nameplate which states the vehicle
was custom built for their Department.
CAB DOOR TRIM REFLECTIVE
The interior of each door shall include a white reflective tape installed vertically along the outer rear
edge of the door. Also a 12.00 inch reflective octagon stop sign shall be installed on the inner door panel
of each door.
INTERIOR GRAB HANDLE "A" PILLAR
There shall be two (2) rubber covered 11.00 inch grab handles installed inside the cab, one on each “A”
post at the left and right door openings. The left handle shall be located 7.88 inches above the bottom of
the door window opening and the right handle shall be located 2.88 inches above the bottom of the door
window opening. The handles shall assist personnel in entering and exiting the cab.