Specifications

The cab interior shall include trim on the front ceiling, rear crew ceiling, and the cab walls. It shall be
easily removable to assist in maintenance. The trim shall be constructed of insulated vinyl over a hard
board backing.
REAR WALL INTERIOR TRIM
The rear wall of the cab shall be trimmed with vinyl.
HEADER TRIM
The cab interior shall feature header trim over the driver and officer dash constructed of 5052-H32
Marine Grade, 0.13 inch thick aluminum.
TRIM CENTER DASH
The main center dash area shall be constructed of 5052-H32 Marine Grade, 0.13 inch thick aluminum
plate. There shall be four (4) holes located on the top of the dash near each outer edge of the electrical
access cover for ventilation.
TRIM LH DASH
The left hand dash shall be constructed of 5052-H32 Marine Grade, 0.13 inch thick aluminum plate for a
perfect fit around the instrument panel and the lower control panels to the left and right of the steering
column.
TRIM RH DASH
The right hand dash shall be constructed of 5052-H32 Marine Grade, 0.13 of an inch thick aluminum
plate and shall include a glove compartment with a hinged door and a Mobile Data Terminal (MDT)
provision. The glove compartment size will measure 14.00 inches wide X 6.38 inches high X 5.88
inches deep. The MDT provision shall be provided above the glove compartment.
ENGINE TUNNEL TRIM
The cab engine tunnel shall be covered with a multi-layer mat consisting of 0.25 inch closed cell foam
with a 0.06 inch thick non-slip vinyl surface with a pebble grain finish. The mat shall be held in place by
pressure sensitive adhesive. The engine tunnel mat shall be trimmed with anodized aluminum stair
nosing trim for an aesthetically pleasing appearance.
POWER POINT DASH MOUNT