Specifications

Two (2) spring-loaded hydraulic hold down hooks located outboard of the frame shall be installed to
hold the cab securely to the frame. Once the hold-down hooks are set in place, it shall take the
application of pressure from the hydraulic cab tilt lift pump to release the hooks.
Two (2) cab tilt cylinders shall be provided with velocity fuses in each cylinder port. The cab tilt pivots
shall be 1.90 inch ball and be anchored to frame brackets with 1.25 inch diameter studs.
A steel safety channel assembly, painted safety yellow shall be installed on the right side cab lift
cylinder to prevent accidental cab lowering. The safety channel assembly shall fall over the lift cylinder
when the cab is in the fully tilted position. A cable release system shall also be provided to retract the
safety channel assembly from the lift cylinder to allow the lowering of the cab.
CAB TILT LIMIT SWITCH
A cab tilt limit switch shall be installed. The switch will effectively limit the travel of the cab when
being tilted. The limit adjustment of the switch shall be preset by the chassis manufacturer to prevent
damage to the cab or any bumper mounted option mounted in the cab tilt arc. Further adjustment to the
limit by the apparatus manufacturer shall be available to accommodate additional equipment.
CAB TILT CONTROL RECEPTACLE
The cab tilt control cable shall include a receptacle which shall be temporarily located on the right
hand chassis rail rear of the cab to provide a place to plug in the cab tilt remote control pendant. The
tilt pump shall include 8.00 feet of cable with a six (6) pin Deutsch receptacle with a cap.
The remote control pendant shall include 20.00 feet of cable with a mating Deutsch connector. The
remote control pendant shall be shipped loose with the chassis.
CAB WINDSHIELD
The cab windshield shall have a surface area of 2825.00 square inches and be of a two (2) piece
wraparound design for maximum visibility.
The glass utilized for the windshield shall include standard automotive tint. The left and right windshield
shall be fully interchangeable thereby minimizing stocking and replacement costs.
Each windshield shall be installed using black self locking window rubber.
GLASS FRONT DOOR
The front cab doors shall include a window which is 27.00 inches in width X 26.00 inches in height.
These windows shall have the capability to roll down completely into the door housing. This shall be
accomplished manually utilizing a crank style handle on the inside of the door. A reinforced window
regulator assembly shall be provided for severe duty use.