Specifications

FRONT BUMPER APRON
The 21.00 inch extended front bumper shall include an apron constructed of 0.19 inch thick embossed
aluminum tread plate.
The apron shall be installed between the bumper and the front face of the cab affixed using stainless
steel bolts attaching the apron to the top bumper flange.
FRONT BUMPER COMPARTMENT CENTER
The front bumper shall include a compartment in the bumper apron located in the center between the
frame rails which may be used as a hose well. The compartment shall be constructed of 0.13 inch
5052-H32 grade aluminum and shall include drain holes in the bottom corners to allow excess moisture
to escape. The compartment shall include a cover constructed of 0.19 inch thick bright embossed
aluminum tread plate.
FRONT BUMPER COMPARTMENT COVER HARDWARE
The front bumper compartment cover shall include gas cylinder stays which shall hold the cover open.
The cover shall held in the closed position via a flush push button style latch.
MECHANICAL SIREN
The front bumper shall include an electro mechanical Federal Q2B™ siren, which shall be streamlined,
chrome-plated and shall produce 123 decibels of sound at 10.00 feet. The Q2B™ siren produces a
distinctive warning sound that is recognizable at long distances. A unique clutch design provides a
longer coast down sound while reducing the amp draw to 100 amps. The siren shall measure 10.50
inches wide X 10.00 inches high X 14.00 inches deep.
MECHANICAL SIREN LOCATION
The siren shall be pedestal mounted on the bumper apron on the furthest outboard section of the bumper
on the driver side.
AIR HORN
The front bumper shall include two (2) Hadley brand E-Tone air horns which shall measure 21.00 inches
long with a 6.00 inch round flare. The air horns shall be trumpet style with a chrome finish on the
exterior and a painted finish deep inside the trumpet.
AIR HORN LOCATION