Specifications

The doors shall include a double rolled style automotive rubber seal around the perimeter of each door
frame and door edge which ensures a weather tight fit.
All door hinges shall be hidden within flush mounted cab doors for a pleasing smooth appearance and
perfect fit along each side of the cab. Each door hinge shall be piano style with a 0.38 inch pin and
shall be constructed of stainless steel.
CAB ENTRY DOOR TYPE
All cab entry doors shall be full length in design to fully enclose the lower cab steps.
CAB INSULATION
The cab ceiling and walls shall include 1.00 inch thick foam insulation. The insulation shall act as a
barrier absorbing noise as well as assisting in sustaining the desired climate within the cab interior.
CAB STRUCTURAL WARRANTY
Summary of Warranty Terms:
THE FOLLOWING IS SUMMARY OF WARRANTY TERMS FOR INFORMATION ONLY. THE
ACTUAL LIMITED WARRANTY DOCUMENT, WHICH IS ATTACHED TO THIS OPTION,
CONTAINS THE COMPLETE STATEMENT OF THE SPARTAN CHASSIS, INC. LIMITED
WARRANTY. SPARTAN’S RESPONSIBILITY IS TO BE ACCORDING TO THE TERMS OF
THE COMPLETE LIMITED WARRANTY DOCUMENT.
The cab structure shall be warranted for a period of ten (10) years or one hundred thousand (100,000)
miles which ever may occur first. The warranty period shall commence on the date the vehicle is
delivered to the first end user.
CAB TEST INFORMATION
The cab shall have successfully completed the preload side impact, static roof load application and
frontal impact without encroachment to the occupant survival space when tested in accordance with
Section 4 of SAE J2420 COE Frontal Strength Evaluation Dynamic Loading Heavy Trucks, Section 5 of
SAE J2422 Cab Roof Strength Evaluation Quasi –Static Loading Heavy Trucks and ECE R29 Uniform
Provisions Concerning the Approval of Vehicles with regard to the Protection of the Occupants of the
Cab of a Commercial Vehicles Annex 3 Paragraph 5.
The above tests have been witnessed by and attested to by an independent third party. The test results
were recorded using cameras, high speed imagers, accelerometers and strain gauges. Documentation of
the testing shall be provided upon request.
ELECTRICAL SYSTEM