Specifications

Smeal Pumper Demo # 4276
Page 55 of 58
polypropylene faceplates, which are backlighted, so that plug orientation to the receptacles is quick and
easy to align.

The junction box shall be equipped with an Akron Brass model CS cord stop.
A tread plate mounting bracket shall be included.
There shall be one (1) NEMA 5-20R, 120 volt, duplex, 3-wire, straight blade (household type) GFCI
receptacle installed in the junction box. The receptacle shall have a 20 ampere rating.

There shall be one (1) NEMA L5-15R, 120 volt, duplex, 3-wire, twistlock receptacle installed in the
junction box. The receptacle shall have a 15 ampere rating.

There shall be two (2) NEMA L5-20R, 120 volt, single, 3-wire, twistlock receptacles installed in the
junction box. Each receptacle shall have a 20 ampere rating.

The reel shall be located in the T1 compartment.
RECEPTACLE
There shall be one (1) NEMA L5-20R, 120 volt, single, 3-wire, twistlock receptacle installed on the
apparatus. The receptacle shall have a 20 ampere rating and include a spring-loaded weather resistant
cover if mounted in an exterior location.

The receptacle shall be located in the right rear wheel area. 
RECEPTACLE
There shall be one (1) NEMA L5-20R, 120 volt, single, 3-wire, twistlock receptacle installed on the
apparatus. The receptacle shall have a 20 ampere rating and include a spring-loaded weather resistant
cover if mounted in an exterior location.

The receptacle shall be located in the left rear wheel area. 
BODY PAINT PREPARATION
After the body and components have been fabricated and assembled they then shall be disassembled
prior to painting so when the apparatus is completed there shall be finish paint beneath the removable
components. The apparatus body and components shall be metal finished as follows to provide a
superior substrate for painting.

All aluminum sections of the body shall undergo a thorough cleaning process starting with a phosphoric
acid solution to begin the etching process followed by a complete rinse. The next step shall consist of a
chemical conversion coating applied to seal the metal substrate and become part of the aluminum
surface for greater film adhesion.

After the cleaning process, the body and its components shall be primed with a High Solids primer and
the seams be caulked.
