Specifications

Smeal Pumper Demo # 4276
Page 54 of 58
The 120 volt light shall be controlled with a circuit breaker.

The light shall be located on the rear of the chassis cab on the left side. 
TELESCOPING 120 VOLT LIGHT(S)
There shall be an Extenda-Lite/Akron Brass model ELSS-XLAC-PS-SM2 scene light with side mount
push-up telescoping pole installed on the apparatus. All mounting brackets and pole fittings shall be
heavy duty, cast aluminum that are powder painted white to match the light head. Each telescoping pole
shall be equipped with an Akron Brass LED SceneStar Light. The light head shall contain 48 high power
LEDs and a highly polished reflector. The light head shall operate from 120 VAC and maintain a stable
light output of 20,000 lumens and constant power consumption of 1.8 amps. All inside and outside poles
shall be made only from drawn aluminum tubes. Each pole shall be deep etched, wire brushed and clear
anodized to ensure a corrosion free appearance and lasting durability. The telescoping pole(s) shall
rotate 360 degrees left or right and the light head tilt up and down.

The 120 volt light shall be controlled by two (2) switches. One (1) switch shall be located in the chassis
cab and one (1) switch shall be located on the pump operator's panel. Each switch shall be a momentary
activation switch so the light can be activated in one location and deactivated in the other.

The 120 volt light shall be controlled with a circuit breaker.
The light shall be located on the rear of the chassis cab on the right side. 
ELECTRIC CORD REEL
There shall be Akron Brass, model ERWC-15-10, electric rewind cord reel installed on the apparatus. The
cord reel shall be equipped with a universal frame that will allow the 12 volt motor to be mounted in four
(4) different positions. All metal parts, except for the electric motor and sprocket teeth, shall be powder
painted red. All hardware shall be stainless steel. The cord reel disks shall have rolled edges to prevent
sharp edges. The cord reel shall include the solenoid, switch and circuit breaker. The reel shall be
covered by an Akron Brass five (5) year warranty. Rollers be supplied to prevent damage to the electrical
cable if pulled in any direction.

Shop Note: The reel shall be centered in the T1 compartment and shall be mounted as high as possible.

The cord reel shall be equipped with 200' of yellow STW Seoprene 10/3 wire installed with a cable stop to
prevent damage to cable fittings.

JUNCTION BOX
There shall be an Akron Brass Extenda-Lite, model EJBX, back lighted electrical junction box equipped
with four (4) electrical receptacles, two (2) per side. Each receptacle shall be equipped with a spring
loaded snap cover. The cord reel shall be prewired to the cast aluminum junction box to supply power to
the four (4) receptacles. An extension cord shall be connected to the junction box through a heavy-duty
water resistant strain relief and flexible extender. Each side of the junction box shall be fitted with