Specifications

Smeal Pumper Demo # 4276
Page 53 of 58
LOWER ZONE D

There shall be one (1) Weldon, model V46W-R, LED light with chrome flange installed. The light shall
have a red lens.

WELDON V46S 12 VOLT LED SCENE LIGHTS
There shall be two (2) Weldon Diamondback LED V46S Scenelights bezels installed.
The 12 volt rear scene light shall be controlled by a switch located in the chassis cab. The switch shall
have an indicator that shall illuminate when the switch is in the “ON” position. The light shall be controlled
by one (1) switch. The switch shall be labeled "REAR SCENE."

In addition to the switch located in the cab, the 12 volt rear scene light shall be activated by the rear work
light switch and when the apparatus is placed in reverse.

The 12 volt scene light shall be located on the rear of the apparatus body.
BROW MOUNT 12 VOLT LIGHT(S)
There shall be an Extenda-Lite/Akron Brass model ELSS-SLDC-BL scene light with brow mount bracket
pole installed on the apparatus. The mounting bracket shall attach to the bottom of the lighthead and be
machined to conform to the roof radius. All mounting brackets shall be heavy duty, cast aluminum that are
powder painted white to match the light head. Wiriong shall extend from a weatherproof strain relief at the
rear of the lighthead. The Akron Brass LED SceneStar light head shall contain 8 high power LEDs and a
highly polished reflector. The light head shall operate from 10-32 VDC and maintain a stable light output
of 14,000 lumens and constant power consumption of 220W.

There shall be (2) remote switches provided; one (1) on the pump operator’s panel and one (1) in the
chassis cab for the 12 volt light.

The light shall be located on the front of the chassis in the center. 
TELESCOPING 120 VOLT LIGHT(S)
There shall be an Extenda-Lite/Akron Brass model ELSS-XLAC-PS-SM2 scene light with side mount
push-up telescoping pole installed on the apparatus. All mounting brackets and pole fittings shall be
heavy duty, cast aluminum that are powder painted white to match the light head. Each telescoping pole
shall be equipped with an Akron Brass LED SceneStar Light. The light head shall contain 48 high power
LEDs and a highly polished reflector. The light head shall operate from 120 VAC and maintain a stable
light output of 20,000 lumens and constant power consumption of 1.8 amps. All inside and outside poles
shall be made only from drawn aluminum tubes. Each pole shall be deep etched, wire brushed and clear
anodized to ensure a corrosion free appearance and lasting durability. The telescoping pole(s) shall
rotate 360 degrees left or right and the light head tilt up and down.

The 120 volt light shall be controlled by two (2) switches. One (1) switch shall be located in the chassis
cab and one (1) switch shall be located on the pump operator's panel. Each switch shall be a momentary
activation switch so the light can be activated in one location and deactivated in the other.
