Specifications

Smeal Pumper Demo # 4276
Page 52 of 58
120/240 volt electrical system shall be installed in strict compliance with NFPA 1901. This shall include all
testing, labeling, wiring methodology, and dimensional requirements. Certification of compliance shall
accompany the apparatus at the time of delivery. All 120/240 volt A.C. Wiring shall be done in accordance
with NFPA 1901 as well as nationally accepted electrical codes.

BRANCH CIRCUIT OVERCURRENT PROTECTION
Over current protection devices shall be provided for circuits in accordance with NFPA 1901. The load
center shall be equipped with a non-GFI two pole main breaker when the six or more individual branch
circuits are present. Over current protection devices shall be marked with labels to identify the function of
the circuit they protect.

The load center shall be located on the forward bulkhead of the L1 compartment.
There shall be one (1) splash guard/drip pan installed inside the compartment. The aluminum drip pan
shall catch drops of water that accumulate on the shutter and drip into the shutter compartment when the
door is being rolled up. The plastic splash guard shall act to keep water from being splashed throughout
the interior of the compartment while the door is being rolled up. The pan shall also serve to protect the
shutter from damage due to impact from behind or below.

UPPER ZONE A
There shall be one (1) Weldon Aero-Maxx II, 59" LED lightbar installed on the chassis cab roof. The
lightbar shall be equipped with six (6) forward facing red LED modules, four (4) forward facing white LED
modules, two (2) side facing red LED modules.

The lightbar shall be equipped with clear lenses. All clear LED lights in the lightbar shall be deactivated in
the Blocking Right of Way mode.

UPPER ZONE C
There shall be two (2) Weldon, model 7150-7160-10 LED beacons installed high at the rear of the
apparatus. The beacons shall have red LEDs and lenses.

UPPER ZONE B
UPPER ZONE D
LOWER ZONE A
The warning lights shall be supplied and installed by the chassis manufacturer.
LOWER ZONE B
There shall be one (1) Weldon, model V46W-R, LED light with chrome flange installed. The light shall
have a red lens.

LOWER ZONE C
There shall be Two (2), Weldon, model V46W-R LED lights installed. The lights shall have red lenses.