Specifications

Smeal Pumper Demo # 4276
Page 5 of 58
DRAWINGS

All bid drawings shall be stamped PRELIMINARY DRAFT. 
 A total of six (6) "C" size (18" x 24") drawings and one (1) 11" x 17" drawing shall be supplied
 All drawings shall be drawn and printed in a 3/8 to 1 scale
 Compartment door opening dimensions shall be shown on table on the drawing which shall refer
to each compartment number, such as L1, R1, T1
 Drawings shall be five (5) views. (left, right, front, rear, top) with the exception of chassis that are
not always available as AutoCAD drawings
 Rear plumbing, such as 2-1/2" discharges, rear steamers, and direct tank fills, shall be shown
 Ladders shall be labeled with a letter designation referring to the table for an explanation of the
ladder type
 OAL (overall length) in feet & inches - 
Estimated length shall be rounded up to the nearest inch
 OAH (overall height) in feet & inches
Estimated height shall be rounded up to the nearest inch
 Body dimensions shown - pump house width & front of the body to centerline of the rear axle
 Wheelbase in inches
 Estimated in-service weight
 Turning clearance radius
 Front and rear overhang in inches
 No pump panel or instrument panel controls, discharges or inlets. To be blank and labeled "Pump
Panel"

 Water tank outline
 Foam tank(s) fill towers
 Exterior mounted hard suction hose
 Warning lights
 D.O.T. lights
 Generator outline
 No front bumper layout