Specifications

Smeal Pumper Demo # 4276
Page 43 of 58
the rub rail that is installed on the body to maintain a uniform appearance. The depth of the rear deck
shall be 13.25". The rear deck shall be installed with sufficient support to form a sturdy, non-deflecting
step area for personnel.

REAR STEPS
There shall be three (3) Cast Products bolt-on steps installed on the rear of the apparatus. Each step
shall have large open slots to prevent buildup of ice or mud and to provide a handhold when necessary.
Steps shall be provided in the following locations:

 Three (3) bolt-on steps on the left rear of the apparatus.
The steps shall be adequately lit with LED lighting. There shall be one (1) light located above the set of
steps on the rear face of the body. The light shall be located in a manner that shall light all of the steps.

FRONT BODY STEPS AND LIGHTING
There shall be three (3) Cast Products folding steps located on the front of the right side body
compartments. The folding steps shall have two large open slots to prevent the buildup of ice or mud and
to provide a handhold when necessary. The steps shall have a surface area of at least 35 square inches
and shall be able to withstand a load of 500 pounds.

The steps shall be adequately lit with LED lighting. There shall be one (1) light located above the steps.
FRONT VERTICAL AREA TREAD PLATE OVERLAYS
There shall be a tread plate overlay on the vertical areas of each side of the apparatus body. The overlay
will be located in front of the L1 and R1 compartments.

REAR WHEEL WELLS
The fenders shall be integral with the body sides and compartments with a seamless appearance. The
fenders shall be fitted with bolt-in removable full circular inner liners in the wheel well area for ease of
cleaning and maintenance. There shall be sufficient clearance provided in the wheel well to allow the use
of tire chains when the apparatus fully loaded.

STAINLESS STEEL REAR FENDERETTES
Two (2) stainless steel fenderettes shall be installed at the outboard edge of the rear wheel well area, one
on each side. The fenderettes shall be bolted to the apparatus body using nylon washers to space them
slightly away from the body to reduce build-up of road grime. The fenderettes shall be constructed of
stainless steel that has been polished to a high quality finish.

LEFT SIDE REAR WHEEL WELL POSITION - WL1
There shall be a single air bottle compartment installed in the rear wheel well area. The compartment
door, hinges and frame shall all be constructed out of stainless steel material. The door shall have a
rubber gasket in order to create a 100% seal to protect the interior of the compartment. The storage
compartment shall be a rotational, molded component that is assembled to the door and frame. This