Specifications

Smeal Pumper Demo # 4276
Page 41 of 58
- Door Opening 41.00" wide x 53.50" high
- Usable Depth 25.75" lower and 15.25" upper
- Intermediate divide height 25.50"

There shall be one (1) ROM rollup door installed on the compartment face. The door shall be a shutter
type with 34 millimeter slats that roll onto a spool at the top of the compartment. Each slat shall be
equipped with nylon end shoes to assure operation without the need of constant lubrication. The rollup
door shall have a satin finish.

The ROM rollup door shall be supplied with a full width lift bar and finger pull handle integrated into the
bottom rail for easy one hand operation.

The compartment shall have one (1), 42" ROM V4 LED compartment light installed. The light shall feature
solid state construction and be waterproof to IPX7 rating. The V4 LED light shall offer 250 lumens per foot
of lighting.

There shall be four (4) galvanneal strut channels, two (2) per side, installed in the full depth portion of the
compartment. In the shallow depth portion of the compartment there shall be two (2) strut channels, one
(1) per side.

There shall be one (1) application in the compartment that shall utilize Dri-Dek interlocking squares. Each
square shall be made from polyvinyl chloride that is flame and chemical resistant. For maximum slip
resistance and drainage, each square shall have a knobby perforated surface.

REAR BODY CONFIGURATION
COMPARTMENT T1
There shall be a full height compartment located at the rear of the apparatus body. This compartment
shall be designated as T1 within these specifications and any ensuing paperwork or drawings after
contract execution.

- Door Opening 41.00" wide x 42.00" high
- Usable Depth 30.00"

There shall be one (1) ROM rollup door installed on the compartment face. The door shall be a shutter
type with 34 millimeter slats that roll onto a spool at the top of the compartment. Each slat shall be
equipped with nylon end shoes to assure operation without the need of constant lubrication. The rollup
door shall have a satin finish.

The ROM rollup door shall be supplied with a full width lift bar and finger pull handle integrated into the
bottom rail for easy one hand operation.

The compartment shall have two (2), 36" ROM V4 LED compartment lights installed. Each light shall
feature solid state construction and be waterproof to IPX7 rating. Each V4 LED light shall offer 250
lumens per foot of lighting.

There shall be one (1), roll out equipment tray installed on the floor of the compartment. The tray shall be
equipped with an Austin Hardware drawer slide. The roller assembly shall have a rated capacity of 300