Specifications

Smeal Pumper Demo # 4276
Page 40 of 58
There shall be one (1), aluminum adjustable shelf installed on the apparatus in the shallow depth
compartment. The shelf shall be constructed of 3/16" aluminum sheet with 2" lips. The shelf shall have an
abraded finish and shall be designed in such a manner as to allow liquids to readily drain when spilled.

There shall be two (2) applications in the compartment that shall utilize Dri-Dek interlocking squares.
Each square shall be made from polyvinyl chloride that is flame and chemical resistant. For maximum slip
resistance and drainage, each square shall have a knobby perforated surface.

There shall be one (1), roll out equipment tray installed on the floor of the compartment. The tray shall be
equipped with an Austin Hardware drawer slide. The roller assembly shall have a rated capacity of 300
lbs. distributed load and shall have 100% extension capability. The tray shall be constructed of 3/16"
aluminum sheet with 3" lips to prevent items from being shifted during transportation. The tray shall be
equipped with the Austin Hardware front drawer release system which allows for one handed latch closed
position release. The tray shall have an abraded finish and shall be equipped with a locking slide in order
to hold the tray in either a fully extended or closed position.

COMPARTMENT R2
There shall be a standard height compartment located above the rear wheels on the right side of the
apparatus body. This compartment shall be designated as R2 within these specifications and any ensuing
paperwork or drawings after contract execution.

- Door Opening 57.00" wide x 24.00" high
- Usable Depth 15.25"

There shall be one (1) ROM rollup door installed on the compartment face. The door shall be a shutter
type with 34 millimeter slats that roll onto a spool at the top of the compartment. Each slat shall be
equipped with nylon end shoes to assure operation without the need of constant lubrication. The rollup
door shall have a satin finish.

The ROM rollup door shall be supplied with a full width lift bar and finger pull handle integrated into the
bottom rail for easy one hand operation.

The compartment shall have two (2), 12" ROM V4 LED compartment lights installed. Each light shall
feature solid state construction and be waterproof to IPX7 rating. Each V4 LED light shall offer 250
lumens per foot of lighting.

There shall be one (1) application in the compartment that shall utilize Dri-Dek interlocking squares. Each
square shall be made from polyvinyl chloride that is flame and chemical resistant. For maximum slip
resistance and drainage, each square shall have a knobby perforated surface.

There shall be two (2) galvanneal strut channels, one (1) per side, installed in the standard height
compartment.

COMPARTMENT R3
There shall be a full height compartment located behind the rear wheels on the right side of the apparatus
body. This compartment shall be designated as R3 within these specifications and any ensuing
paperwork or drawings after contract execution.
