Specifications

Smeal Pumper Demo # 4276
Page 37 of 58
The water tank shall rest on the sub frame cross members which are spaced as required by the tank
manufacturer.

The tank shall be isolated from the cross members through the use of hard rubber strips with a minimum
Rockwell hardness of 60 durometer. Additionally, the tank shall be supported around the entire perimeter
and captured both, front and rear as well as side to side to prevent the tank from shifting during vehicle
operations.

Although the tank shall be designed on a free floating suspension principle, it shall be required that the
tank have adequate hold down restrains to minimize movement during vehicle operations.

The tank shall be completely removable without disturbing or dismantling the apparatus structure.
EXHAUST HEAT DEFLECTOR SHIELD
There shall be a 5" heat deflector shield installed over the exhaust to aid in dissipating the heat to prevent
exhaust heat from adversely affecting anything stored in the body.

LEFT SIDE BODY CONFIGURATION
COMPARTMENT L1
There shall be a full height compartment located ahead of the rear wheels on the left side of the
apparatus body. This compartment shall be designated as L1 within these specifications and any ensuing
paperwork or drawings after contract execution.

- Door Opening 29.00" wide x 53.50" high
- Usable Depth 25.75" lower and 15.25" upper
- Intermediate divide height 26.50"

There shall be one (1) ROM rollup door installed on the compartment face. The door shall be a shutter
type with 34 millimeter slats that roll onto a spool at the top of the compartment. Each slat shall be
equipped with nylon end shoes to assure operation without the need of constant lubrication. The rollup
door shall have a satin finish.

The ROM rollup door shall be supplied with a full width lift bar and finger pull handle integrated into the
bottom rail for easy one hand operation.

The compartment shall have one (1), 42" ROM V4 LED compartment light installed. The light shall feature
solid state construction and be waterproof to IPX7 rating. The V4 LED light shall offer 250 lumens per foot
of lighting.

There shall be four (4) galvanneal strut channels, two (2) per side, installed in the full depth portion of the
compartment. In the shallow depth portion of the compartment there shall be two (2) strut channels, one
(1) per side.

There shall be one (1), aluminum adjustable shelf installed on the apparatus in the shallow depth
compartment. The shelf shall be constructed of 3/16" aluminum sheet with 2" lips. The shelf shall have an
abraded finish and shall be designed in such a manner as to allow liquids to readily drain when spilled.
