Specifications

Smeal Pumper Demo # 4276
Page 31 of 58
keeping the covers rigid under fast filling conditions. A minimum of two lifting dowels shall be drilled and
tapped 1/2" x 13" to accommodate the lifting eyes.

WATER TANK MOUNTING
The water tank cradle shall be an integral part of the body sub-frame. Please reference the sub-frame
section for complete water tank mounting information.

WATER TANK DRAIN
There shall be a 1-1/2" drain valve provided under the sump of the water tank. The valve handle shall be
extended to the outside edge of the body for ease of access. The handle shall include a locking lever to
prevent accidental draining of the water tank.

4" WATER TANK SLEEVES
The United Plastic Fabricating water tank shall contain the appropriate number of 4" tank sleeves for
plumbing to the rear of the apparatus.

WATER TANK FILL TOWER
The tank shall have a combination vent and manual fill tower marked "Water Fill." The fill tower shall be
constructed of 1/2" PT2E™ polypropylene and shall be a minimum dimension of 8" x 8" at the outer
perimeter. The tower shall be located in the left front corner of the tank. The tower shall have a 1/4" thick
removable polypropylene screen and a PT2E™ polypropylene hinged-type cover. The fill tower shall be
black in color.

6" WATER TANK OVERFLOW
The tank shall be equipped with a minimum of a 6" schedule 40 polypropylene overflow/air vent pipe. The
pipe shall be installed in the fill tower and extend through the tank and dump to the rear of the rear axle.

WATER TANK LEVEL GAUGE
There shall be one (1) Class 1 Intelli-Tank™ water tank level gauge provided on the pump operator's
control panel. The water tank level gauge shall indicate the water level on an easy to read LED display
and show increments of 1/8 of a tank. The water tank level gauge shall include:

1. A pressure transducer that is mounted on the outside of the tank in an easily accessible area.
2. A super bright LED 4-light display with a visual indication at nine accurate levels.
3. A set of weather resistant connectors to connect to the digital display, to the pressure transducer
and to the apparatus power.

FOAM CELL
There shall be one (1) United Plastic Fabricating 20 U.S. gallon foam cell incorporated into the water
tank. There shall be one (1) pressure/vacuum vent installed on the foam tank. There shall be one (1)
drain hose connected to the foam cell. The drain shall have a quarter-turn valve installed inside the pump
module and it shall drain below the frame rail of the chassis.
