Specifications

Smeal Pumper Demo # 4276
Page 29 of 58
There shall be one (1) Trident model 01.006.0, 2-1/2" NH vented rocker lug cap with chain provided. The
cap shall have a chrome finish.

There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a brown color
coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to the
back for assembly into the bezel. The bezel shall be die cast aluminum construction and color coded on
all visible surfaces with an automotive grade paint. 3M VHB adhesive shall be applied to the back.

3" DELUGE RISER DISCHARGE
There shall be a 3" discharge for the deluge located above the pump module. The discharge shall be
centered in the pump module.

An Akron Brass model 8630 3" Swing-Out™ valve shall be provided. The valve shall have an all brass
body with flow optimizing stainless steel ball and dual polymer seats. The valve shall be capable of dual
directional flow while incorporating a specially designed flow optimizing stainless steel ball. The valve
shall not require lubrication of seats or any other internal waterway parts, and must be capable of
swinging out of the waterway for maintenance by the removal of six bolts. The valve shall be
manufactured and assembled in the United States. The valve shall carry a ten (10) year warranty by the
valve manufacturer.

The valve shall be actuated by an Akron Brass manual gear actuator installed on the valve. The gear
actuator shall operate at a 50:1 gear ratio, which operates from fully open to fully closed in twelve (12)
rotations.

The gear actuator shall be controlled by an Akron Brass 4" handwheel valve controller. The handwheel
worm gear shall be connected to the remote mounted valve via a rod assembly. The handwheel shall turn
a gear sector mounted on the valve for smoother and easier operations under pressure. A position
indicator shall show the position of the ball valve as per NFPA 1901. Opening and closing speed shall
comply with the current NFPA standard to minimize effects of water hammer.

There shall be a Trident Emergency Products 3/4" quarter-turn drain valve included. There shall be a
chrome plated rectangular handle provided on the drain valve to facilitate use with a gloved hand. The
drain valve shall be located just above the running board and below the pump panel to reduce clutter in
the pump panel area. The drain valve shall be connected to the valve with flexible hose that is routed in
such a manner as to assure complete drainage to below the apparatus. A matching color coded bezel
shall be included.

There shall be a Thuemling 2-1/2" water pressure gauge installed. The pressure gauge shall read
pressure in PSI and shall be capable of reading 0-400 PSI. The gauge shall be fully filled with pulse and
vibration dampening liquid to insure proper operations to minus 40 degrees and to reduce lens
condensation. A removable polished, stainless steel trim ring shall be provided with the gauge.

DECK GUN RISER PIPE
The riser for the deck gun shall terminate with a 4-bolt flange.
There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a magenta color
coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to the