Specifications

Smeal Pumper Demo # 4276

Page 26 of 58

An Akron Brass model 8820 2" Swing-Out™ valve shall be provided. The valve shall have an all brass

body with flow optimizing stainless steel ball and dual polymer seats. The valve shall be capable of dual

directional flow while incorporating a self-locking ball feature using an automatic friction lock design and

specially designed flow optimizing stainless steel ball. The valve shall not require lubrication of seats or

any other internal waterway parts, and must be capable of swinging out of the waterway for maintenance

by the removal of six bolts. The valve shall carry a ten (10) year warranty by the valve manufacturer.



The valve shall be actuated by an Akron Brass model R1 manual actuator installed on the valve.

The manual actuator shall be controlled by a Trident push/pull T-handle. The handle shall be chrome

plated with a recessed ID label.



There shall be a Trident Emergency Products 3/4" quarter-turn drain valve included. There shall be a

chrome plated rectangular handle provided on the drain valve to facilitate use with a gloved hand. The

drain valve shall be located just above the running board and below the pump panel to reduce clutter in

the pump panel area. The drain valve shall be connected to the valve with flexible hose that is routed in

such a manner as to assure complete drainage to below the apparatus. A matching color coded bezel

shall be included.



There shall be a Thuemling 2-1/2" water pressure gauge installed. The pressure gauge shall read

pressure in PSI and shall be capable of reading 0-400 PSI. The gauge shall be fully filled with pulse and

vibration dampening liquid to insure proper operations to minus 40 degrees and to reduce lens

condensation. A removable polished, stainless steel trim ring shall be provided with the gauge.



The discharge shall terminate MNST thread.

The discharge shall be designated as a pre-connect and no cap and chain shall be supplied.

There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a yellow color

coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to the

back for assembly into the bezel. The bezel shall be die cast aluminum construction and color coded on

all visible surfaces with an automotive grade paint. 3M VHB adhesive shall be applied to the back.



1-1/2" CROSSLAY PRE-CONNECT

There shall be a 1-1/2" crosslay pre-connect with 2" plumbing.