Specifications

Smeal Pumper Demo # 4276
Page 23 of 58
There shall be one (1) Trident model 01.006.0, 2-1/2" NH vented rocker lug cap with chain provided. The
cap shall have a chrome finish.

There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a orange color
coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to the
back for assembly into the bezel. The bezel shall be die cast aluminum construction and color coded on
all visible surfaces with an automotive grade paint. 3M VHB adhesive shall be applied to the back.

2-1/2" RIGHT SIDE DISCHARGE
There shall be a 2-1/2" discharge, with 2-1/2" plumbing, located on the right side of the pump module.
An Akron Brass model 8825 2-1/2" Swing-Out™ valve shall be provided. The valve shall have an all
brass body with flow optimizing stainless steel ball and dual polymer seats. The valve shall be capable of
dual directional flow while incorporating a self-locking ball feature using an automatic friction lock design
and specially designed flow optimizing stainless steel ball. The valve shall not require lubrication of seats
or any other internal waterway parts, and must be capable of swinging out of the waterway for
maintenance by the removal of six bolts. The valve shall carry a ten (10) year warranty by the valve
manufacturer.

The valve shall be actuated by an Akron Brass model R1 manual actuator installed on the valve.
The manual actuator shall be controlled by a Trident push/pull T-handle. The handle shall be chrome
plated with a recessed ID label.

There shall be a Trident Emergency Products 3/4" quarter-turn drain valve included. There shall be a
chrome plated rectangular handle provided on the drain valve to facilitate use with a gloved hand. The
drain valve shall be located just above the running board and below the pump panel to reduce clutter in
the pump panel area. The drain valve shall be connected to the valve with flexible hose that is routed in
such a manner as to assure complete drainage to below the apparatus. A matching color coded bezel
shall be included.

There shall be a Thuemling 2-1/2" water pressure gauge installed. The pressure gauge shall read
pressure in PSI and shall be capable of reading 0-400 PSI. The gauge shall be fully filled with pulse and
vibration dampening liquid to insure proper operations to minus 40 degrees and to reduce lens
condensation. A removable polished, stainless steel trim ring shall be provided with the gauge.

The discharge shall terminate MNST thread.
There shall be one (1) Trident model 01.002.0, 2-1/2" Female NST swivel rocker lug x 2-1/2" Male NST
45º elbow adapter provided. The adapter shall be cast brass with a chrome plate finish. The female swivel
shall be attached using ball bearings.

There shall be one (1) Trident model 01.006.0, 2-1/2" NH vented rocker lug cap with chain provided. The
cap shall have a chrome finish.

There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a light green
color coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to