Specifications

Smeal Pumper Demo # 4276
Page 20 of 58
A short steamer barrel shall be installed to accommodate an intake valve without exceeding the legal
overall body width.

There shall be a Neles Jamesbury model 815W butterfly valve provided. The valve shall be a 6" full flow
valve with a 6" NST nipple. The valve shall be controlled by a hand wheel located on the pump panel, on
the same side as the valve. The valve shall meet current NFPA standards for opening and closing speed.

There shall be a Class 1 bleeder valve provided on the steamer inlet. The valve shall be used to bleed off
air or water as per NFPA requirements.

INTAKE RELIEF VALVE
There shall be an Elkhart Brass intake relief valve installed on the suction side of the pump. The valve
shall be the preset type, adjustable from 75 to 250 PSI, and shall be designed to prevent vibration from
altering the setting. The relief outlet shall be directed below the pump with the discharge terminating in a
2-1/2" male NST connection. The discharge shall be away from the pump operator and labeled "Do Not
Cap".

There shall be a Trident Emergency Products 3/4" quarter-turn drain valve included. There shall be a
chrome plated rectangular handle provided on the drain valve to facilitate use with a gloved hand. The
drain valve shall be located just above the running board and below the pump panel to reduce clutter in
the pump panel area. The drain valve shall be connected to the valve with flexible hose that is routed in
such a manner as to assure complete drainage to below the apparatus. A matching color coded bezel
shall be included.

The intake shall terminate MNST thread.
There shall be one (1) Trident model 01.003.9, 6" NST vented long handle steamer cap provided. The
cap shall have a chrome finish.

There shall be a two (2) piece permanent plate installed that includes a verbiage tag and a chrome color
coded bezel. The verbiage tag shall be etched on aluminum and have 3M-468 adhesive applied to the
back for assembly into the bezel. The bezel shall be die cast aluminum construction and color coded on
all visible surfaces with an automotive grade paint. 3M VHB adhesive shall be applied to the back.

2-1/2" LEFT SIDE INLET
There shall be a 2-1/2" gated inlet, with 2-1/2" plumbing, provided on the left side of the pump module.
The inlet shall be located towards the rear of the pump module and shall be partially recessed behind the
panel in order to keep the valve protected from the elements.

An Akron Brass model 8825 2-1/2" Swing-Out™ valve shall be provided. The valve shall have an all
brass body with flow optimizing stainless steel ball and dual polymer seats. The valve shall be capable of
dual directional flow while incorporating a self-locking ball feature using an automatic friction lock design
and specially designed flow optimizing stainless steel ball. The valve shall not require lubrication of seats
or any other internal waterway parts, and must be capable of swinging out of the waterway for
maintenance by the removal of six bolts. The valve shall carry a ten (10) year warranty by the valve
manufacturer.
