Specifications

There shall be two (2) access points to the seat frame storage area, one (1) on each side of the seat
frame. Each access point shall be covered by a hinged door which measures 15.00 inches in width X
10.63 inches in height.
SEAT MOUNTING FORWARD FACING CENTER
The forward facing center seats shall be installed facing the front of the cab.
CAB FRONT UNDERSEAT STORAGE ACCESS
The left and right under seat storage areas shall have a solid aluminum hinged door with non-locking
latch.
SEAT COMPARTMENT DOOR FINISH
All underseat storage compartment access doors shall have a Zolatone #20-71 onyx black texture finish.
WINDSHIELD WIPER SYSTEM
The cab shall include a dual arm wiper system which shall clear the windshield of water, ice and debris.
There shall be two (2) windshield wipers which shall be affixed to a radial wet arm. The system shall
include a single motor which shall initiate the arm in which both the left hand and right hand windshield
wipers are attached, initiating a back and forth motion for each wiper. The wiper motor shall be
activated by an intermittent wiper control located within easy reach of the driver’s position.
ELECTRONIC WINDSHIELD FLUID LEVEL INDICATOR
The windshield washer fluid level shall be monitored electronically. When the washer fluid level
becomes low the yellow “Check Message Center” indicator light on the instrument panel shall
illuminate and the message center in the dual air pressure gauge shall display a “Check Washer Fluid
Level” message.
CAB DOOR HARDWARE
The cab entry doors shall be equipped with exterior pull handles, suitable for use while wearing
firefighter gloves. The handles shall be made of a fiber reinforced plastic composite with a black matt
finish.
The interior exit door handles shall be flush paddle type with a black finish, which are incorporated into
the upper door panel.
All cab entry doors shall include locks which are keyed alike. The door locks shall be designed to
prevent accidental lockout.