Specifications

Smeal Pumper Demo # 4276
Page 10 of 58
The actual wheelbase of the vehicle shall be approximately 174".

ANGLE OF APPROACH
The actual angle of approach of the vehicle shall be approximately 12 degrees.
ANGLE OF A DEPARTURE
The actual angle of departure of the vehicle shall be approximately 12 degrees.
VEHICLE TOP SPEED
The apparatus Gross Vehicle Weight Rating (GVWR) is over 26,000 lbs. The vehicle’s top speed shall be
68 mph.

MISCELLANEOUS EQUIPMENT ALLOWANCE
The Gross Axle Weight Rating (GAWR) and the Gross Combined Weight Rating (GCWR) or Gross
Vehicle Weight Rating (GVWR) of the chassis shall be adequate to carry the weight of the unequipped
apparatus with the water tank and other tanks full, specified hose load, unequipped personnel weight,
ground ladders, and miscellaneous equipment allowance of 2,000 pounds.

MISCELLANEOUS EQUIPMENT
Miscellaneous equipment, as defined by NFPA 1901, sections 5.8.2 and 5.8.3, shall be the responsibility
of the customer. The apparatus shall be designed and manufactured in such a manner as to provide
ample enclosed space for which to store such equipment.

OWNER'S MANUALS
There shall be an owner's manual containing the construction, operation, and service documentation
provided on a USB Drive. There shall be one (1) copy of the USB provided with the apparatus.

ELECTRICAL SYSTEM SCHEMATIC
A complete electrical schematic for the apparatus shall be provided. This schematic shall be specifically
prepared for this individual unit rather than a generic schematic designed to accommodate all apparatus.

FINAL INSPECTION
The customer and/or dealer representative will inspect the final apparatus prior to it leaving the apparatus
body manufacturer’s facility. This will allow any changes that may be required, to be done so in a timely
and inexpensive manner. After leaving the facility, all repairs or alterations will be performed by either the
Dealer or an OEM approved service center.

INSPECTION CERTIFICATE - NFPA 1901 COMPLIANCE
A third party inspection certificate for the apparatus shall be furnished upon delivery. The purpose of this
NFPA 1901 compliance inspection shall be to serve as proof to the customer that all applicable standards
have been met or exceeded by the responsible manufacturer.
