Owner`s manual

Page 8 of 28 RD0169 (A) CAF730 & SS730 OWNER’S MANUAL
When flown as part of a CAF730 array, the SS730s should be the uppermost enclosures in the
array. In this application, the SS730s are suspended flat-fronted, with the CAF730s suspended
below in the curvature determined by the CAF730 Wizard.
When flown separately, SS730s should be flown so that the spacing between the line of SS730
enclosures and CAF730 enclosures is about 1 ft / 0.3 m. The SS730 should be suspended in a flat-
fronted configuration.
4.4.4 Other Subwoofers
Other subwoofers, such as thewoodworxmax SSX220, SS600z SS1000z, or BS760, can also be used
with CAF730s. Recommended quantities of CAF730 for each subwoofer are:
Model Subwoofer CAF730
SSX220 2 3
SS600z 1 2
BS760 1 4
SS1000zR 1 2
4.4.5 Signal Delay on Subwoofers
If SS730s are flown or stacked withCAF730s as configured in the CAF730 Wizard, use the factory
signal delay settings.
For other configurations or subwoofers, it will usually be necessary to determine the signal delay
settings by measurement.