Owner`s manual

Page 22 of 28 RD0169 (A) CAF730 & SS730 OWNER’S MANUAL
5. Attach each Hinge to the Hinge Tube by inserting a Quick Release Pin (removed in Step
2) through both.
6. Insert a Quick Release Pin (removed in step 2) into each of the enclosure’s rear Hinge
Tubes as a locking pin. See “Locking Pins” Section 6.4.5.
7. Lift the Array, with the CAF730 attached only by its rear Hinges, to a comfortable working
height for the next step.
8. Employing two people, one lifts the front of the CAF730, rotating it on the attached rear
Hinges.
9. The second person slides the CAF730’s front Hinges into the suspended CAF730’s Hinge
Tubes.
CAUTION: When attaching the front Hinges, the normal configuration is tight packing the
enclosure fronts unless otherwise configured by the Wizard.
NOTE: It will usually be necessary to nudge the CAF730 enclosure being attached backwards
to line up its Hinges with the Hinge Tubes on the suspended enclosure above.
10. Attach each Hinge to the Hinge Tube by inserting a Quick Release Pin (removed in step
7) through both.
11. Repeat Steps 1 to 10 for additional CAF730s.
6.7.7 Setting the Tilt Angle for the Entire Array
Normally, the easiest method is to use a clinometer, such as a simple, bubble-
type angle finder (pictured). More sophisticated, albeit more expensive,
electronic clinometers can also be used.
Place the angle finder against one of the rigging tubes on the face of the
uppermost enclosure in the array that can be physically reached. Adjust the
angle of the entire array so that the face of this enclosure is set at its
prescribed aiming angle listed in theCAF730 Wizard on the Array Tab.
6.8 GROUND STACKING PROCEDURES
Up to six CAF730s and up to four SS730s may be ground-stacked. Always stack CAF730s using the
SS730(s) or the CAF730 Fly-Bar as a base for the stack.
DANGER: A ground stack of more than six CAF730 enclosures may shift the center of gravity
making the stack unstable. Failure to follow this warning may result in damage to the equipment
damage, injury, or death.
6.8.1 Stacking With SS730(s) as the Base
IMPORTANT NOTE: If using one or more SS730s as the stacking base, all CAF730 and SS730
enclosures are stacked right side up. Always stack all SS730s underneath the CAF730s.
1. At the desired stacking location, position an SS730 on the floor with the Hinges on the
top, this being the normal orientation for suspension.