User`s manual


5.5 DIP Switch Setting (Available for standard models: SS-1200/1500/2000/3000)
Function Table of DIP Switch
Switch No.
1 2 3 4
Function Up Down Up Down Up Down Up Down
Voltage = 100V / 200V V V
Voltage = 110V / 220V V V
Voltage = 115V / 230V V V
Voltage = 120V / 240V V V
Frequency for DC Start 50Hz 60Hz
Green Power
(Enable/Disable)
Yes No
P.S.: Program setting active only after the UPS is re-started.
5.6 Remote Control:
The UPS can be set for daily shutdown/wake up. This command must be set
through the RS-232 interface. When this function is set, the timer inside the UPS
will begin to run, and the load will be turned off by the shutdown/wake up schedule.
During the period of turn off to the next turn on, the status LED blinks red every 2
seconds. .
5.7 Reset the UPS
If any abnormal condition occurs, and the item 4.2.1 ~ 4.2.4 can not be executed,
please push the button for at least 10 sec. until the status LED becomes orange,
then the UPS is reset.
1 2 3 4
DIP Switch