User`s manual


5. INDICATION AND CONTROL
5.1 Battery level and load level LEDs
The battery level LEDs show the voltage level both in back-up mode and in normal
mode. When the LED indicates 20% of the capacity in back-up mode, it means
that the UPS is going to shut down; for the length of backup time left, it will depend
on the load. While when all five LEDs light in normal mode, it means that the
battery is fully charged.
The load level LEDs show the percentage of added load by the UPS rated capacity.
When all five LEDs light, the UPS is over loaded.
5.2 Operation status LED
The status LED shows the UPS status, in the normal utility power duration, LED shows
Green. In the event of a utility outage, LED shows Orange. If the UPS is under fault
operation, LED shows Red.
5.3 Audible alarm
During a utility failure or fault operation, the UPS emits beep for warning. In back-up
mode, the beeping can be silenced by pushing the button. However, the warning of
low battery will still sound for urging user to leave computer without any data loss.
Basic Indication Table:
LED ALARM PERIOD STATUS
Green No Beep One flash every 2 sec. Utility Good
Orange No Beep One flash every 2 sec. Utility outage
Idle mode
Red No Beep One flash every 2 sec. Timer on, refer to Item 5.6
Green No Beep Continuously Normal
(Utility good)
One beep every 4 sec. Back-up
(No load)
Orange Yes, can be silenced
2 beeps every 4 sec. Back-up
(Loading)
Orange No, can Not be
silenced
4 beeps per sec. Battery Low
Normal/
Back-up mode
Red Yes 8 beeps per sec. Battery NG.
5.4 Auto self-test Function:
In normal mode of UPS, turn on your computer and push the button on the front panel
for self-test. The UPS will simulate a power outage and transfer your load to the
UPS battery. If low battery warning sounds during the test, it means that the battery
set is weak and requires extended recharge. If battery NG warning sounds, it means
that the battery set is damaged and requires replacement.