User manual

Operating the Unit
3. Adjusting the Wrist-Band
a. After attaching the electrode pads, place the Stop Snoring
Device one inch below the wrist like a watch. Use the wrist
strap to tighten/loosen it and then secure into position using
the fastener.
b. Tighten and fix this end of the strap.
Note: Don’t pull the strap too tightly; it could result in
poor circulation.
The device functions best when touching the skin gently.
4. Using the Device
a. Test the function of the device before use. Switch on the
power and adjust the intensity to level 1.
b. Press the test button three times in a row. Check that the
LED indicator (green light) is blinking. The device will
release a weak electrical impulse that lasts for about 5
seconds. You can adjust the intensity to the level you like.
6
I
II
III
SS650 User manual.indd 8 1/15/07 3:47:00 PM