User manual

User’s FAQ
4. When I ‘simulate’ the snores in a silent background, why does the device not work?
A: Since the Stop Snoring Device special biosensor is designed according to
the biophysical properties of snoring, you can try to ‘simulate’ it by saying a long 1, 2,
3 or producing 3 consecutive snores with the same frequency and at least above 65 dB.
5. Why do I feel one long stimulation? Is something wrong with the device?
A: This is a special built-in design. As the microprocessor monitors your snoring
frequency and after the device has had a sequence of 15 outputs, it emits a 25-second
long stimulation to cause the heavy snoring person to change his/her sleeping position.
6. Are the two sides of the electrode pad different? Does it matter if there is no
proper contact?
A: Yes, the two sides are different. To tell them apart, the side of the electrode pad
that is to be attached to the device has stronger adhesion (the side with printed words
on the waxed protective film). The device will work as long as the electrode pads are
properly attached to the black conductive rubber pads on the device.
Do not place the two electrode pads too closely to each other, as this will affect
conductivity. In the event that the pads are stuck together, gently peel apart and
resume proper attachment.
14
SS650 User manual.indd 16 1/15/07 3:47:06 PM