Instruction manual

-12-
SPECIFICATIONS
Input Voltage 10 - 16 VDC (negative ground)
Input Current 8 Amps @ 13.6 VDC (100W speaker)
Standby Current Less than 20 mA
Output Power 105 WATTS RMS MAX. (15.0 VDC - single 100W speaker)
Siren Frequency 675Hz - 1633Hz
High Voltage Protection 16 - 18 VDC will cause siren output to cease, resume at normal
Short Circuit Current 50 AMPS (supply circuit must be capable of supplying this)
Operating Temperature -15° F to +140°F
Controls 3-position primary mode rocker switch (Wail, Yelp, and Standby)
Momentary 3-position rocker switch (Horn and Manual)
Phaser disable (jumper programmable)
Two-Tone Enable (jumper programmable)
Auxiliary Horn Polarity (jumper programmable)
Two 2-Position Light Control Switches (LCS652 only)
Connections
(12-Pin Connector)
Detachable, 12-pin, positive locking connector with pigtail leads
(1) Positive, (1) Negative, (2) Speaker, and (1) auxiliary Horn.
LCS652 only: (2) Additional Positive
Size 2” High, 6” Wide, 5¼” Deep
Boxed Weight 3.5 lbs.
PARTS
The following parts are available from Signal Vehicle Products:
Part Description
P30235-19P Amplifier Top Cover
P30234-19P Amplifier Bottom Mounting Plate
SWH-27 SS650 Wiring Harness
SWH-83 LCS652 Wiring Harness
30052-30 Rear Amplifier Case Screws
30052-26 Bottom Amplifier Case Screws
30028-6 15 Amp Automotive Blade Fuse for Amplifier
30032-8 TIP36C Power Transistor
30007-41 3-Position Rocker Selector Switch (WAIL/YELP)
30007-42 Momentary Rocker Switch (HORN/MAN)
SW-40 Lighted ON/OFF Rocker Switch (LCS652)