User manual

Page
42
4.4.4 NetService
Choose the network service option and click the set button to configure the parameters.
Picture 4.18 NetService
【PPPoE setup】
Picture4.19 PPPOE
Input the user name and password that ISP（Internet service provider ）provides. After saving it
reboot up your system. Then the NVR will build a network connection based on PPPoE. The IP address
will change into dynamic IP address after above operation is well done.
Operation：After PPPoE dialing successfully look up the IP address in the [IP address] and obtain
the current IP address. Then use this IP address to visit the NVR through user port.
【NTP setup】