User manual

Page
36
alarm is turned on.
【Delay】Delay a few moments and stop when the alarm state is turned off. The range is 10~300
seconds.
【 Record channel 】 Choose the recording channel (multiple option supportive). Trigger the video
signal when the alarm is turned on.
Note:Set in the [recording setup] and perform the linkage recording. Start detecting video files
in the corresponding time section.
【Tour】The selective channel is single window alternate patrol preview.The interval is set in the
[MainMenu]> [Tour].
【PTZ Activation】Set the PTZ activation when the alarm is turned on.
Note:PTZ activation is set in the [shortcut menu] >[ PTZ control]. Set the patrol between spots,
trail patrol and so on.
Picture 4.7 PTZ Activation
【Delay】When alarm is over,recording will last some seconds(10~300sec),then stop.
【Show message】Pop the alarm information dialog box in the local host computer screen.
【Send EMAIL】 means sending an email to user when the alarm is turned on.
Note:Set in the [NetService] and send email.
【FTP upload】 means upload the alarm images to your ftp when the alarm is turned on.
【Buzzer】Device buzzers when NVR detects alarm .
4.3.2 Video Blind
When the video image is influenced by the environment such as bad brightness or reaching the set
sensitivy parameter, the camera mask function is turned on and the linkage function is turned on.