User manual

Page
13
3.3 System Login and Add IP cameras
3.3.1 System Login
When the NVR boots up, the user must login and the system provides the corresponding functions
with the user purview. There is one user settings. The name is Admin and has no password. Admin is
the super user purview. User Admin’s password can be revised, while their permissions can’t be
revised.
Picture 3.1 System Login
Password protection: If the password is continuous wrong ten times, the account will be
locked. (Through reboot or after half an hour, the account will be unlocked automatically).
For your system security, please modify your password after first login.
3.3.2 NVR add IP cameras
(1)To add ip cameras to NVR , please go to "Main Menu -- Add IPC" . NVR will search the ip camras
in LAN automatically.Click “ADD to add the device to the channel list below.Click “OK” to Save after
adding devices. You can click "Modify" to change the configuration of the ip cam.
For example,when you setup an ipc with onvif protocol,the IP Address should be in the same
network segment with nvr,port uses the searched port,protocol is onvif,resolution/user name/password
should be the same as that on ipc.