Specifications

32
(5) Instruction when adding the local storage device
① Open the system body and install a new disk (connect the data cable and the power cable)
② Connect power to the system and boot the system.
③ Select {Menu}  {Setup}  {Storage} by using the arrow keys and the Select button.
④ A newly displayed disk will then be displayed as {New}.
⑤ Select a newly installed disk by using the arrow keys and the Select button and initialize the
disk as a {Recording} or a {Backup} disk. The following describes the method of setting the
recording storage.
⑥ {Recording} shows the status of the newly installed disk online.
※ Selecting {Recording-Format} or {Backup-Format} causes all data in the device to be
erased. Therefore, caution is required.
※ While {Recording-Format} or {Backup-Format} is being set up, do not remove the device
(may cause an error when detecting the device).
※ To use the external or portable storage device for system upgrade, set to {Backup-Init} in
the {New} item for {Main Setup} {Storage Device} {Local Storage Device Management}.
※When used in NVR equipment for the first time, a backup USB device will always be
detected in the {New} category. Therefore, a USB device in the {New} category must be set
up as {Backup-Format} prior to use for backup. A USB device that has gone through this
procedure will be detected in the {Backup} category when used again in the NVR equipment.
(6) How to changed FAULT HDD
① Check Faulty HDD number
② Turn OFF unit by power button.
③ Detach cover of NVR
④ Find the faulty HDD by number printed on mainboard
⑤ Detach the faulty HDD
⑥ Attach new HDD.
⑦ Attach cover of NVR
(7) HDD Format for Recording
Select the model first.
As shown below, proceed with the following order {New}  {Recording-Format}.