Installation Manual

ValveWatch II Hardware Installation and Setup Manual
Page 31 of 34
CRANE
Nuclear
9.5 Static Pressure Sensor Wiring
The static pressure sensor kit is provided with a cable for connecting the pressure sensor to the
LDAU enclosure. Route the sensor cable in site approved cable tray or tubing to the enclosure.
Route the cable through an appropriate cable gland and secure. Connect the four strain sensor
conductors and cable shield conductor as required on J-51008ExS. Connect the cable connector
into the sensor connector.
Yellow - SIG +
Green - SIG –
Brown - EXC +
White - EXC -
Shield - Ground terminal
10 Installation Inspection
Perform inspection and/or testing of the system installation in accordance with local requirements.