User Manual

05 06
The position of the stripped
coated fiber is placed
Rubber-covered Wireoptical Fiber
Placement Position
Position of tail fiber
Bare fiber
Rubber-covered Wire
Tail fiber
1.Peel off the 28-33mm coating and wipe
the fiber clean with alcohol.
2.Put the clean fiber into the holder base
and pay attention to the position of the
coating layer.
3.Close the cover of the holder and
the fiber cleaver will automatically
cut (Automatic cutting function will
be turned on by App default)
Open by default
SF-10
Operation instructions
Operation instructions
OPTICAL FIBER CLEAVER
Electric precision
SF-10
OPTICAL FIBER CLEAVER
Electric precision
1.Peel off 33-38mm of the outer plastic skin
of therubber-covered wire with stripping
pliers, and then peel off 28-33mm of the
optical fiber the coating is wiped with
alcohol to clean the fiber.
2.Put the clean optical fiber into the holder
base. Note the position of the plastic skin
shown in the figure
1.The outer plastic skin of the tail fiber is
stripped off 33-38mm with Miller stripper, and
the strengthened velvet is cut off with scissors.
Then the middle plastic skin is stripped off 28-
33mm with Miller stripper. Finally, the fiber
coating of 28-33mm is stripped off with the
smallest mouth of Miller stripper, and the fiber
is wiped clean with alcohol.
2.Put the clean optical fiber into the holder
base. Note the position of the plastic skin
shown in the figure.