User Manual

15 16
The fiber is not straight when cutting
Press the cut key and there is no reaction
Abnormal mechanism action
The power button cannot be started
Automatic shutdown when cutting
Using the fiber cleaver APP, connect the fiber cleaver and add the pull value by 1 to 3 in [Cut type] –
[Adjust pull value].
It may be that the fiber cleaver entered the blade replacement mode and did not exit.
Please restart the fiber cleaver or click "Device Reset" on the fiber cleaver APP. If still
not working, please return to the factory for repair.
Please return to the original factory for inspection and repair
It may start up immediately after shutting down, and wait 5 seconds before starting up again
after each key.
The battery is low, please charge it.
The Fiber Cleaver Is Not Cut After Placing The Fiber
The Clamping Surface Of The Fiber Cleaver Cannot
Hold The Optical Fiber Or Clip Off The Optical Fiber
Glitch
Angle Is Big
The End Face Is Uneven And Cracked
The Optical Fiber Has Transverse Knife Grain
The Fiber Cleaver Does Not Cut Fiber
Optical Fiber End Face Irregularity
The Blade Is Not In The Normal Cutting Position
How To Deal With Fiber Breaking In Cutting
Process
How To Deal With The End Face Of Optical
Fiber Cut With Fiber Cleaver
Clean the left and right splint surfaces and the jig rubber pads
Check whether there are broken fibers or residues on the two clamping surfaces of the fiber,
use a brush to clean it or wipe it with alcohol cotton, and then relocate the fiber
The tension is too small, increase the tension by 1-2
The tension is too small, increase the tension by 1-2
The tension is too large, reduce 1-2 tension values
Clean left and right splint surface and fixture rubber pad
Clean left and right splint surface and fixture rubber pad
Clean left and right splint surface and fixture rubber pad
Long press the cutting button on the fiber cleaver for 1.5 seconds, and the fiber cleaver is reset
Using the fiber cleaver APP, connect the fiber cleaver and reduce the pull value by 1 to 3
values in [Cut type] - [Adjust pull value].
Using the fiber cleaver APP, connect the fiber cleaver and add the pull value by 1 to 3 values
in [Cut type] - [Adjust pull value]. If it is still not ideal, it may be because the cutting blade is
not sharp enough due to too many times of use, please change the blade.
SF-10
Common problems and solutions
Common problems and solutions
OPTICAL FIBER CLEAVER
Electric precision
SF-10
OPTICAL FIBER CLEAVER
Electric precision