User's Manual

Tele

Eye

User

Guide Page 57

Setup

Tele

Eye RX for Modem Connection

Setup Procedure

Step 1: Connect cameras to

Tele

Eye RX {Video Input} with RG59 cable and BNC

connector.

Note that the cameras system is either NTSC or PAL and suppose all cameras are used the

SAME system format. (For PTZ camera installation, please refer P.148 to Advance Operation

Section of the User Guide).

Step 2: Connect CCTV monitor to

Tele

Eye RX {Video Output} with RG59 cable and BNC

connector.

Step 3: Install and use the bundled key to lock the {Hard Disk Rack} with hard disk to the

Tele

Eye RX.

Note that you cannot perform recording and playback if there is no hard disk installed but

still has live video monitoring. (For hard disk installation details, please refer P.11 to Hard

Disk Installation Section of the User Guide)

Step 4: Connect the power adapter (12V DC, 5A supply) to the

Tele

Eye RX.

Step 5: Turn on the power of

Tele

Eye RX, camera and CCTV monitor. Check the

{Power LED} which is lit up in blue color continuously at

Tele

Eye RX front

panel after power on. After several seconds, live video appears on the CCTV monitor

as follow:

Note that: Please go through the following steps (6-10) if the video of CCTV Monitor does

not show clearly.