User's Manual

Tele Eye
RX
User
Guide Page 39
Setup
Tele
Eye RX for Broadband or Narrowband
Internet Connection with Static IP

Enter an IP address, subnet mask and
Default gateway. Note that IP address
should be “192.168.0.xx” except
“192.168.0.2” which is
Tele
Eye RX
default IP address.

Enter the Preferred and Alternate DNS
server, if necessary.
 Click OK to activate the new IP.
 You have to confirm that IP address has
been correctly set on your computer. On
your windows, click start > run, type
“cmd” at Open field and press OK button,
then type “ipconfig” on the DOS prompt,
you will see an IP set on your computer.
10/100 BASE-T
LINK COL

Connect the PC Ethernet socket to the
transmitter Ethernet socket at rear panel of
the transmitter with cross-over Ethernet
cable. Check if the {LINK LED} of the
transmitter is turned
ON
.

Run WX-30 software which has been
installed to the PC. (For details of WX-30
software installation, please refer to WX-
30 Software Guide)