User's Manual

Tele Eye RX User
Guide Page 20
Setup
Tele Eye RX for Local CCTV Monitor
Setup Procedure
Step 1: Connect cameras to
Tele
Eye RX {Video Input} with RG59 cable and BNC
connector.
Note that the cameras system is either NTSC or PAL and suppose all cameras are used
the SAME system forma.
(For PTZ camera installation, please refer P.148 to Advance
Operation Section of the User Guide).
Step 2: Connect CCTV monitor to
Tele
Eye RX {Video Output} with RG59 cable and
BNC connector.
Step 3: Install and use the bundled key to lock the {Hard Disk Rack} with hard disk to the
Tele
Eye RX.
Note that you cannot perform any recording and playback if there is no hard disk
installed but still has live video monitoring.
(For hard disk installation details, please refer
P.11 to Hard Disk Installation Section of the User Guide)
Step 4: Plug in the power adapter (12V DC, 5A supply) to the
Tele
Eye RX.
Step 5: Turn on the power of
Tele
Eye RX, camera and CCTV monitor. Check the
{Power LED} which is lit up in blue color continuously at
Tele
Eye RX front
panel after power on. After several seconds, live video appears on the CCTV
monitor as follow:
Note that : Please go through the following steps (6-10) if CCTV Monitor does not show
video clearly