User's Manual

Tele Eye
RX
User
Guide Page 156
General Team Discussion
B
GENERAL TERMS DISCUSSION
Before you start to configure the transmitter, you may need to know some of the terms and
information used in the transmitter.

Registration Checking
Users need to do the registration in the
Tele
Eye Reception Software WX-30 for
authorization before the transmitter can be used when such feature is enabled in the
Tele
Eye
RX. This option can be applied to improve the security protection for the organization when
higher security level is required. If the transmitter is decided to open for public use, you can
disable this feature so that public users do not need to register for viewing live video from the
Tele
Eye Reception Software WX-30.
 Site Monitoring Method
There are mainly four methods to link up with the transmitter to see video:

Telephone Line (Public Telephone Network/ISDN)

TCP/IP in LAN

TCP/IP on the Internet using Broadband and Internet Router

TCP/IP on the Internet using Broadband with Dial-up Software
You have to choose one of the connection methods in Section 3 to configure the transmitter
before use so as to make it function properly.
The
Tele
Eye Reception Software WX-30 contains all the settings for different remote
video monitoring method. Different connection methods may have different settings, and
some of the setting configured in one connection method is not applicable to other method. In
this case, you can refer to one of the following configuration procedures for the connection
method you will use.
ʳ
ʳ
It is recommended that the above items should be configured before the first time you use the
transmitter no matter which connection method you use. The steps to set the above items are
discussed in Section 3 : Basic Installation for Local and Remote Monitoring.
A
PPENDI
X