User's Manual

Tele Eye
RX
User
Guide Page 108
Event Handling
II. Security Switch
Security Switch
It is an input to the transmitter for wiring a security switch. The purpose of the security switch
is to terminate the exit delay for exit zone alarm. If the security switch is on and the system is
armed, all exit delay will be terminated. If the security switch is off and an entry alarm
triggered, entry delays will start.
Security Switch Tamper Type
Security switch tamper event triggers if someone cuts the wire between the security switch
input and the transmitter. This event behaves as fire zone type that can be triggered once the
wire being cut. Arm/Disarm tamper type has choice of none, SEOL, DEOL. (Please refers to
P.100 Tamper Circuit Section of the User Guide)
On State
The security switch input circuit type is normal close (NC). The state of the circuit is close, it
indicates security switch off of
Tele
Eye RX. Otherwise, the state of the circuit is open, it
indicates security switch on of
Tele
Eye RX. The security switch input circuit type is normal
open (NO). The state of the circuit is open, it indicates security switch off of
Tele
Eye RX.
Otherwise, the state of the circuit is close, it indicates security switch on of
Tele
Eye RX.
(For detail usage, please refers to P.111 Alarm Part in Event Handling Section of User Guide.)
Physical Configuration for Security Switch
The security switch input and ground of
Tele
Eye RX transmitter needs to connect to a control
unit which is commonly the lock of the surveillance area for security switch input.
Control
circuit
Security Switch Input
Ground