User's Manual

Tele Eye
RX
User
Guide Page 105
Event Handling
Zone Type
Although the setting of zone type belongs to alarm menu, it is worth to discuss as below.

Fire Zone
This zone allows alarms to trigger no matter which arm state of the system is, i.e. armed or
disarmed. It is suitable for installation of fire detectors

Normal
This zone allows alarms to trigger after armed.

Entry/Exit Zone
This zone allows user to set the delay time for entering or leaving the surveillance area without
triggering any alarm event. If alarm recording action is enabled, recording starts at entry or exit
time through out the delay.
(For detail usage example, please refers to P.111 Alarm Part in Event Handling Section of User
Guide.)
Physical Configuration for Arm/Disarm
The arm/disarm input and ground of
Tele
Eye RX transmitter needs to connect to a control unit
which is commonly a switch or password panel for arm/disarm input.
Control
circuit
Arm/Disarm Input
Ground
Arm/Disarm Setup Procedure
Step 1: Press “Menu” button, select
[SETUP] option and press “Enter”
button to enter [SETUP] sub
menu. Select [EVENT HANDLER]
option and press “Enter”
button.
SETUP MENU
VIDEO . . .
RECORDING . . .
SWITCHES . . .
DATE / TIME . . .
CONNECTION . . .
EVENT HANDLER . . .
TRANSMITTER . . .
SHUT DOWN ENTER