User's Manual

Tele Eye III+ Network Camera Installation Guide Page 1
Before You Begin
BEFORE YOU BEGIN
Modification of the Power Adapter
The connector of the power adapter might require some modifications before connecting it
to the Network Camera.
1. Use a cutting tool to cut off the connector of the adapter
2. Strip the plastic covering off from the cable. You should see the cable is of the coaxial
type
3. After stripping off the plastic cover, you should see the braided GND wrapping
around the plastic shield. Unwrap the braided GND and twist it into a single
wire.
4. Strip off the plastic shield to reveal the 12V wire
5. Now, you should have a 12V wire and a separated GND wire.
PREFACE
Plastic Covering
Braided GND
Plastic
Shield
12V wire
CAUTIONS: NEVER SHORT THE 12V AND GND WIRES. With
the power on, damages may be incurred to the adapter.