User's Manual

Tele Eye III+ Network Camera Installation Guide Page 25
Appendix
Two of them are very important for setup. One of them is used for your local intranet (the field
may contain the name of your Ethernet card), the other one is used for your broadband Internet
connection. An example is shown in the following figure.
TCP/IP-> HP EN1207D-TX PCI 10/100 Fast
Ethernet Adaptor
Used for Intranet (local network)
TCP/IP-> Network TeleSystems P.P.P.o.E
Adaptor
Broadband Internet Access (Point-to-Point
Protocol over Ethernet)
Note that the name of these two TCP/IP adaptors may be different on your computer. You have to
identify the purpose of each corresponding adaptor.
Step 3: Choose TCP/IP->[Your Ethernet card name] > Click Properties > IP address, enter an IP
address “192.168.0.3” and subnet mask “255.255.255.0”
Step 4: Click OK and OK and reboot the computer.
Step 5: After booting, ensure that the computer can still be connected to the Internet.
Step 6: You have to confirm the IP address has been correctly set on your computer. On your windows,
click start > run, type “winipcfg” at Open field and pressed OK button, then you will see a IP
Configuration program shown as figure.